If you heat stopped working try these few steps...
|
#1. Check your Air Filter. Is it dirty?
|
#2. Check the Circuit Breaker. Is it tripped?
|
A dirty air filter can cause the furnace to overheat. It can also lower the
efficiency. Its best to change your air filter(s) every 30-90 days. Also make
sure most or all of your supply vents are open
|
Some breakers my not appear to be tripped or off. By resetting it you will
know for sure.
|
If the breaker is ok then turn the power off at the furnace. Turn it back on
after waiting 10 seconds. This will reset any fault code and may retry for
ignition.
|
#3. Check LED for Error Codes (if equipped)
|
Most furnaces have a circuit board with an LED. It will flash a single or
double digit code by flashing short and or long blinks. Look here...
|
How to shut different valves
|
Ball Valves: turn 90 degrees
|
Gate Valves: turn clockwise until it stops
|
Saddle Valves: turn clockwise until it stops
|
Ball Valves: turn 90 degrees
|
HVAC, Heating, Cooling, Air Conditioning, Humidifiers, Electronic Air Cleaners, EAC's, Boilers, Duct Cleaning, Thermostat, Furnace, Mechanical,
Contractor, Colorado, Colorado Springs, El Paso county, Service, Repair, Cleaning, Install, Amana, American Standard, Armstrong, Air Ease, Bryant,
Carrier, Coleman, Goodman, Heil, Lennox, Payne, Rheem, Trane, Tempstar, York, April Aire, Honeywell, Comfortmaker, frigidaire, general, gibson,
tappan, kenmore, lochinvar, luxaire, magic chef, rinnai, ruud, robertshaw, skuttle, teledyne laars, white rogers, lux, thermostat, hunter, totaline, lg,
samsung, distinctions, janitrol, fedders, weather king.
